Clear-Com TEMPEST 2400 Dokumentacja Pobierz pdf (Strona 38)

Clear-Com Communication Systems Page 38 of 100

Tempest 2400 Wireless Intercom System

Wired Intercom Interface to the Base Station

Each of Tempest’s four wireled intercom channels can interface with a 4-Wire matrix intercom or a 2-Wire

party-line intercom. Tempest supports a 4-Wire intercom interface to most major digital matrix intercom

systems and other intercom 4-Wire devices. Tempest also interfaces with 2-Wire intercom systems

including Clear-Com, RTS, and AudioCom (Bal) systems, as well as compatible brands. Each Tempest

intercom channel can interface with one intercom system at any given time.

While it is possible that both 2-Wire and 4-Wire systems may be connected to the same intercom channel

simultaneously, they cannot function at the same time, and this arrangement has the potential to cause

undesirable operational complications, so is not recommended.

Tempest Base Station Wired Configuration Controls

for Connection to Wired Intercom Systems

These controls will normally be used together to configure the Tempest base station

for 2-Wire or 4-Wire operation.

• Channel A has been set for no wired intercom connection – the LEDs are off.

• Channel B is set for Clear-Com 2-Wire intercom connection. The upper slide switch is in the

middle position and the 2-Wire LED aligned with channel B is illuminated.

• Channels C and D have been set for a 4-Wire interface. The position of the slide switch does not

impact 4-Wire operation.

Tempest base station LCD display for IN and OUT adjustment

Use the IN and OUT controls to adjust the levels on the selected channel.

In this diagram, Channel A, 2-Wire levels are selected for adjustment.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Brak uwag

Clear-Com TEMPEST 2400 Dokumentacja Strona 38